![]() ![]() ![]() I figured out how to add IPv6 manually now but was thinking if this can be auto configured, like if I define the IPv6 address in Apache virtual host and it will start working without manually adding the address in the interface file. If no arguments are given, ifconfig displays the status of the currently active interfaces. After that, it is usually only needed when debugging or when system tuning is needed. It is used at boot time to set up interfaces as necessary. The Debian IPv6 Project does not specify how to disable IPv6 for Wheezy (only kernel level for Squeeze). Run netstat -nr and look for inet6 or Internet6 or similar to. Ifconfig is used to configure the kernel-resident network interfaces. I added the following lines to /etc/network/interfaces: iface eth0 inet6. This parameter puts an IPv6 address at the first place on an interface in. Step 1 Install Teamd on Debian 11 / DebianThe ifconfig command is also used. I got a /64 from my VPS provider, I used to have on-link IPv6 addresses which I used to generate using their control panel, now they give routed subnet, which is something new to me. Finding your IP address Run ifconfig -a and look for inet6 to see your possible IPv6 addresses. To install ifconfig in Debian based Linux distributions like Ubuntu, Kali.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |